IMEC Install

Congratulations to I.M.E.C in Mexico on the installation of their new VulcanPlus Cutting System! Pictured above from left to right: Jose Lizama, Angel Gonzallez, and Bernardo Ramirez

Continue reading →

Aire Proyectos Vulcan Plus Installation

Congratulations to Aire Proyectos in Takpico, Mexico on the installation of their NEW VulcanPlus Cutting System!    

Continue reading →

M&M Manufacturing-Commercial Division Installation

M&M Manufacturing-Commercial Division New Cleat Roller, Insulmatic and Pinspotter Installation Congratulations to M&M Manufacturing on their installation of an Iowa Precision add-on Cleat Roller, Insulmatic and Pinspotter to their existing Coil Line.

Continue reading →

Mammoth Mechanical Installation

Congratulations to the team at Mammoth Mechanical of New Jersey on a successful installation of their Pro Ductomatic and Whisper Loc Pro XVI.

Continue reading →

PSD Exces Elbow Machine Installation

  Congratulations to PSD Exces in Quebec Canada ! Iowa Precision Service Engineer Brad Lowery completed the installation of their NEW Elbow Machine in last week. Pictured on the left is the whole family with Mother, Diane Desrochers, her two...

Continue reading →

General Heating & A/C New Pro-Ductomatic Starter

Chip Burns (Operator) was really excited to get this machine as they had bought an IPI starter line about ten years ago, but have sold it. They were very happy with their first IPI machine and really liked the...

Continue reading →

Walker White New Pro-Fabriduct Full Coil Line Installation

Congratulations to Walker White! Iowa Precision Service Engineer Brad Lowery completed the installation of their NEW ProFabriduct Coil Line last week. They are also proud new owners of a NEW PRO-XVI Whisperlok!  

Continue reading →

Cobb Mechanical Installation

New Pro-Ductomatic Front End Installation Pictured left to right: George H. Kadlec, Shop Superintendent; Jeff Kopish, Mestek Machinery Service Tech; Benjo Colangelo, Operator; in front of their newly installed Pro-Ductamatic front end to their existing Engel downstream line. Congratulations to Cobb Mechanical, a...

Continue reading →

Iowa Precision Plasma Coil Feed

     This machine is designed to feed a plasma cutting table. It is comprised of a drive motor and a series of rolls to feed and remove coil set from the material. The operator uses an on/off switch attached to an...

Continue reading →

Herbert Fischer Joins Mestek Machinery as Senior Project Service Engineer

Mestek Machinery is very pleased to announce that Herbert J. Fischer has joined our organization as Senior Project Service Engineer. Herb has decades of experience in designing equipment and tooling solutions for sheet metal contractors for duct fabrication. Herb spent...

Continue reading →

Lion Equipment Changes

  Mestek Machinery is always engineering improvements into our products. No other sheet metal machinery manufacturer is more dedicated to the betterment of our equipment in the contractor's shop, and in the field. Please be advised of the following design changes...

Continue reading →

Mike Bailey named VP of Sales and Product Management

Stewart Reed, Vice Chairman and COO of Mestek, Inc., and R. Bruce Dewey, President, Mestek Machinery, Inc. are pleased to announce that Mike Bailey of Cummings, Georgia, will be joining the Mestek Machinery domestic sales team effective December 1,...

Continue reading →

Mestek Machinery Paint Color Change

Due to the use of pre-painted items, Mestek Machinery has decided to halt the use of orange paint in the Engel product lines and use safety yellow in its place. Currently, Engel, Lockformer, and IPI use the yellow on their...

Continue reading →